This Audax cutter head arrived with a fried coil and a completely crusted armature. The damping material had not aged well.
A complete disassembly, cleanup and reassembly would be required, with the renewal of the damping material and drive coil. This was yet another perfect candidate for our feedback modification.
Tasos of Epos Laboratory (a Grado retipping specialist) from the beautiful south of Greece is the lucky owner of this 1950's Rek-O-Kut disk recording system.
It consists of a Rek-O-Kut Model V 16" turntable, which he found in the USA (where else?) as a non-runner. The motor was in bad shape and refused to run at all. Even if it would run, it was expecting to be fed on a regular diet of 110 VAC/60 Hz!
In the previous episode, we had a look at taper shank stylus adapters and saw a vintage magnetic monophonic cutter head fitted to the AM44 lathe. The two are not normally compatible. Neumann lathe suspensions do not have the same mount as the suspensions of Presto, Fairchild, RCA and other lathes of the monophonic era, which were originally designed to accept such cutter heads.
But, in fact, almost any cutter head can be fitted to any lathe, as long as there is enough space for it to physically fit, by means of a suitable adapter. The eagle-eyed reader will probably have noticed that the cutter head mount on our prototype AM44 suspension is similar to, but not the same as, the mount used in Neumann suspension boxes. So, the adapter shown here was made specifically for our AM44 suspension unit.
Stereophonic cutter heads developed by Neumann are designed to accept a cutting stylus with a conical shank, resembling a micro-miniature version of a Morse Taper, a type of fitting frequently encountered in machine tools, especially metalworking lathes. Vinylium and FloKaSon cutter heads also adopted the same fitting for the sake of compatibility. But most other cutter heads, especially all those predating the stereophonic era, used long, thin cylindrical shanks, often with a flat machined on one side, to allow a set-screw to align the stylus and secure it in place.
