suspension (5)

SA-74 Suspension Unit Repair From Neumann VMS-70 Disk Mastering Lathe

Repairing an SA-74 suspension unit, from a Neumann VMS-70 disk mastering lathe, which arrived with the head lift/drop lever jammed in the down position, preventing the top lid from being removed! The Neumann SX-74 stereophonic motional feedback cutter head was still attached, as it had been glued to the mount adapter, which can only be removed from the suspension unit by opening the top lid! Several mechanical and electrical repairs, adjustment/calibration procedures and even a bit of machining on the 1961 Moore Special Tools Jig Borer later, it was fully brought back to original specifications!

[MISSING TRANSLATION] J. I. Agnew

Rek-O-Kut Master Pro System with modified Presto 1D Cutter Head

Tasos of Epos Laboratory (a Grado retipping specialist) from the beautiful south of Greece is the lucky owner of this 1950's Rek-O-Kut disk recording system.

It consists of a Rek-O-Kut Model V 16" turntable, which he found in the USA (where else?) as a non-runner. The motor was in bad shape and refused to run at all. Even if it would run, it was expecting to be fed on a regular diet of 110 VAC/60 Hz!

[MISSING TRANSLATION] J. I. Agnew

A New Suspension System for Vintage Lathes

Following up on the progress of the restoration work on a vintage Presto disk recording lathe and the Agnew Analog Reference Instruments Type 6021 Toolpost with integrated oil dashpot, as described in our previous episode, we are now presenting the complete suspension assembly.

[MISSING TRANSLATION] J. I. Agnew

Lab Report: An improved cutter head mounting system with integrated dashpot

The need for a new suspension for our recently presented Presto MRC-16 modification project brought about yet another innovation from our R&D laboratory: The Agnew Analog Reference Instrument Type 6021 Lathe Suspension Toolpost!

Inspired by the toolposts used in metalworking lathes and improving upon the cutter head mounting system used by Neumann, the Type 6021 will accurately and rigidly hold any cutter head fitted with a suitable bar, including Neumann, Vinylium and FloKaSon heads, as well as any other head imaginable, through the use of our Series 1400 head mount adapter range.

[MISSING TRANSLATION] J. I. Agnew

Extensive Disk Recording Lathe Modifications: Fairchild Model 199 converted to Stereo with Caruso Feedback Cutter Head!

Back in 2015, we started a big lathe project, taking a beat-up Fairchild lathe from the 1930's, fitting it with an RCA cutter head, and eventually going full-on with a stereophonic feedback cutter head, vacuum clamp-down platter and automatically variable pitch.

[MISSING TRANSLATION] J. I. Agnew