It consists of a Rek-O-Kut Model V 16" turntable, which he found in the USA (where else?) as a non-runner. The motor was in bad shape and refused to run at all. Even if it would run, it was expecting to be fed on a regular diet of 110 VAC/60 Hz!
Depicted here, are two external rotor, polyphase, electronic commutation motors, fitted to custom mounting plates, ready to be installed in disk recording systems, to control the leadscrew.
These are very high precision motors, with features allowing accurate, closed-loop control of speed over a wide range, as well as positioning applications. A combination of hall sensor arrays and high resolution encoders makes them extremely versatile, compatible with a wide range of lathes.
Back in 2015, we started a big lathe project, taking a beat-up Fairchild lathe from the 1930's, fitting it with an RCA cutter head, and eventually going full-on with a stereophonic feedback cutter head, vacuum clamp-down platter and automatically variable pitch.